Racefit Exhaust?

Discussion in 'Mods, Upgrades, Accessories and Products' started by Mr OCD, Nov 12, 2014.

  1. Mr OCD

    Mr OCD Well-Known Member

    Joined:
    Nov 9, 2014
    Messages:
    2,300
    Likes Received:
    511
    Planned to fit a Racefit Growler to my 2010 Fireblade... but am I correct the bike won't run properly without PCV and mapping?
     
    #1 Mr OCD, Nov 12, 2014
  2. TheRamJam

    TheRamJam Well-Known Member

    Joined:
    Feb 26, 2013
    Messages:
    977
    Likes Received:
    497
    it will run fine mate

    just hunt a little on idle
     
    #2 TheRamJam, Nov 12, 2014
    • Like Like x 1
  3. sps170373

    sps170373 Moderator
    Staff Member

    Joined:
    May 24, 2013
    Messages:
    7,860
    Likes Received:
    3,093
    As above will run fine, just hunt a little on warm up, fitting an o2 eliminator helps (about £15-20) until you fit a pcv
     
    #3 sps170373, Nov 12, 2014
    • Like Like x 1
  4. Mr OCD

    Mr OCD Well-Known Member

    Joined:
    Nov 9, 2014
    Messages:
    2,300
    Likes Received:
    511
    What about the exhaust valves, CAT and O2 sensor?

    Why elimate the O2 sensor?
     
    #4 Mr OCD, Nov 12, 2014
  5. sps170373

    sps170373 Moderator
    Staff Member

    Joined:
    May 24, 2013
    Messages:
    7,860
    Likes Received:
    3,093
    Cat is in the end can so gets removed, servo cable needs detaching and can be junked if you get a servo replacement module then just stick a bolt where the lambda sensor was
     
    #5 sps170373, Nov 12, 2014
    • Like Like x 1

Share This Page