Separate names with a comma.
That’s good to hear…. Moving over
massive pity - as it was such an informtive site. Any admins on her eto block them?
Hi All, been given a couple of bottles of Redex and was wondering if it was suitable for Blade? The blades been sat for most of winter with the...
Did you buy from them in the end? all good?
hi,no not really. Checked the obvious stuff - connectors, side stand switch etc. then went out for a ride and it didn’t fail at all. Not been out...
Any got a set of these front and rear at a sensible price? Looking for the orange wheels (repsol) from a 2012 - 2016 [IMG]
SOLD
Hi All, listed on eBay but I thought I’d also post here. For sale - Arashi Rearsets. Should fit models 2008 to 2016. Arashi Rearsets for Honda...
Like someone said above - I heard alot of bad stories from the local bike community. I heard they essentially take in bikes as PX then clean them...
sorry mate - didn’t quite understand your reply. What do I need to do or look at in terms of the yellow negative block? Is it located in/at main...
Anyone else had this issue and can point me in areas to investigate? The bike will very intermittently cut out when off throttle or slowing down....
Hi All, just an update on this. Finally got this done. Removing old shock was easy but bit of a faff getting the 2014 one in as its a bit taller...
Any recommendations on the Brembo range for a 2008 blade? Seen this online:...
Thanks for info. Did you keep the fluid reservoir as stock or did you change that as well?
Hi, anyone had experience of these? Cheaper than Brembo and seem to get good press. will probably fit the 19mm plug to give best balance of brake...
I believe the answer is yes - but just wanted to check and be aware of any issues/pitfalls. I believe both series 2008-2011 and 2012 to 2016 are...
Hi, looking at fitting a 2014 low mileage rear shock from a 14 blade to my 08 blade. I think its a straight swap - correct? The '14 rear shock...
really need a way to block them as its becoming annoying and will drive away those of us who use this forum.
Hi, purchased some parts from a guy who had a 2009 blade that he was converting to track bike. He had straightened the bars using the original...
Hi All, looking to see if anyone has going for sale a good condition front race fairing and fixings for CBR1000RR years 2008 to 2011. Ideally in...
