Separate names with a comma.
bienvenue carefully check the finish: paint, welding smoothness of the casing and also the quality of fittings. Look for homologation stamps and...
agree with coda. Yuasa should give you 2 years of reliable service without needing charging unless you go 10days + on non use. Is the charging...
sounds normal. the idle is way above normal (11~1300rpm) unless the engine was cold when you shot the video. You may have to budget for sand...
I have noticed from various post that people tend (including my own valve check & adjustment) to find valve clearances too tight. My thinking is...
there are two point to watch here: to immobalise the bike (electronicallu or/ and mechanically to stop the bike being lifted & moved away in a van
you can't go wrong with the rating of this lock. The only comment I have is I would carry a chain to secure the bike to a solid object (groung...
This year, I used 5.1 in both the car & the bikes. The car spec is dot 3 but 4 was used in the past. I went to toyota for the last change and they...
when I first started riding (2003) & looked into locks, I was told Dlocks are not of much benefit and can be easily defeated ahd had not thatcham...
I know the pain with those bolts. You need to use philips or JIS heads and not pozi which can damage the head. I also find they work loose so a...
Been using worth dry lube for years and can’t recommend it enough but it is weak when it comes to corrosion. So started mixing it with xcp. First...
Thanks pal I was just looking for the holy grail of chain lubricating Good wear and rust protection, no fling, easy to apply and clean afterwards...
to me sounds like the engine is either running too rich or the fuel is not burnt properly. You get unburnt fuel in the exhaust whihc pops, bangs...
has anyone used this and what was the outcome? like: ease of application, fling, longetivity and ease of cleaning
Ordered a set from eBay£3 for 8! Arrived today and seem to fit fine. says it’s for 8 mm nipples. Too small for my Yamaha xt.
Part numbers are different between the front and rear/ master cylinder. Prices also around £3 and£5!:confused: Nut sizes are the same though....
Yes they are the ones. Different sizes for front, rear and MC. I haven't lost one but on has cracked. Seen lots on ebay but not sure about the sizes.
What to you guys use as non OEM alternative for these rubber parts? would Like to avoid honda prices!
welcome aboard aaaah! nice bike, cheap petrol, nice roads, nice weather, prettry women.... things I can only dream of theses days. I am very...
14.3 is a healthy charging voltage. The battery drain is too quick. I would check the parasitic current drain to see if it is in spec. If the...
have you checked & cleaned the kill switch contacts?
