Separate names with a comma.
Lol oginbenes like oem have a rubber ring that reduces clatter, fronts are easy to get, rears can be a little harder. Not used on the blade but...
[ATTACH] [ATTACH] Just finished polishing my stainless steel pistons to an inch of their life, 3 stage polish to a mirror finish. like i said...
I’ve just changed mine to gold DID and afam, haven’t actually used it yet due to some global pandemic. the front sprocket in particular looks...
Supersprox are trick too, used it with a tsubaki, can’t remember but the combo did a lot of miles and the sprocket had little wear. Thought id use...
Can’t really comment on 520/530 or gearing changes as no hands on experience. Tsubaki is a pita to rivet as it uses solid rivets unless you have...
I'm testing out a few greases namely Mintex Ceratec and Proslip (Clip, Pad and Pin) Whats this Marine grease you mention? I'm looking for...
I've used the RCS on both abs and non abs. the Abs trickery negates much of the advantages but you do still get much shorter travel. This is on an...
Once my brake pistons are polished and calipers back on the RCS is next
Welcome! You need to get the code from the diagnostics first to point you in the right direction. If you're handy with spanners and can follow...
Actually did mine yesterday while the callipers were off . Mostly all bilt hamber products. Start off with wurth brake cleaner into the bobbin...
These are one of the worst examples, the pitting is close to the edge so caused slight dragging for brand new pads Not sure what would cause such...
Mines been in the shed for a year and half and you've just convinced me to refit it! Not as if I have no time to fit it lol
Not sure about the Accossato as they may have it as well but the RCS19 has both 20 and 18 ratios and brake light switch. I think they say 20 for...
Just to note it's got a weird ass size bleed nipple, depending on your line config the banjo is the wrong length, factor in cost of reservoir mods...
My OEM pistons are pretty fecked, what grease, if any, do you use on the backs of the pads?. Wondering my use of copper slip accelerated the corrosion
If you don't like the soft feel and long travel of OEM then RCS or similar is worth wide. Ran an RCS at the ratio that provides shorter travel...
Bobbin are just a maintenance job to avoid problems and improve performance, I've previously had brembo discs (only the Oros not HPK or T-drive)...
Those piston aren't too bad to be honest! I've recently found over use of solvent cleaners cause the seals to swell so this may have caused the...
Both Wurth in the can and bottle are acetone free too. The burb also says 'Good material compatibility with paints, plastics, seals and rubber'...
Yes that's true and I don't specifically clean the seals with brake cleaner just a strong water based degreaser but I do liberally spray the discs...
