Any ideas where the 'knee rub' and 'top side fairing' go from this diagram? The pieces don't seem to fit anywhere properly lol ...
Fek me you're Brave! Took mine to a 3M specialist for a Pro install, 2 Hrs later and £175 lighter I was on my way!
I've done a few kits and fitting is easy ... Just got nose cone and the bits I mention to install... Looks pretty good.
I fitted a set to my 09 blade knee rub goes on the top upside of the fairing the bit you see when looking down at fairing sitting on bike and the top side is the at the top of the fairing from just under air intake along and below the knee rub piece hope this helps
Well the nose cone has me beat... Got the rest done but after two hours called it a day with the nose cone... I thought it would be easy but there are a couple of curves the film simply won't sit right over ... Will get a Pro to sort it.
If it's the upper parts where the mirror goes, I think by memory you have to give it a pull and stretch it a bit and then push the water/baby shampoo mix out and works then.
It's all one part ... the whole nose cone including upper and lower sections. I cannot get it crease free ... I removed it four times to ensure alignment is perfect and even stretching you get creases ... Did consider heating the film up to help it bend but the issue is then the adhesive warms up and it quickly becomes difficult to work with... I've stuck it back on the backing paper for now .., it's going to need a good soaking in water before its applied again as it's now full of lint! Did a perfect job of the side fairings too... Lol
