Rear sets fitting

Any body fit Gilles rearsets to rr5 with quick shifter fitted,does the bar touch the frame or do you just specie it out tar

 

Ok put spacers in ok now been out on bike shifter not working come on lads any one

 

My Bazzaz rubbed slightly with vortex rearsets on my 09. Spaced the rearsets out and made sure the linkage was as far out on the spline as possible. No drama. My 2014 has enough to clearance without needing spacers.

 

If done spacers but quick shifter not working now for some reason

 

I can't think of a reason why spacing out your rearsets slightly would cause a problem with the QS.

 

Only difference is instead of long ways it's now side ways

 

The link is now straight across and not on a angel

 

Trying to find photos of mine but that doesn't look right ?. Did you get any other parts with the kit ? Is it from an rr4/5 ?
Think the gear shift should be bolted as the original , have to say I'm not totally sure about Gilles, but the gear change forces will be totally different from up / down so you will need to alter the settings on the QS.
Sorry not much help but sure looks odd !!

Will post a pic tomoz if I can dig my way to the bike in the shithole that is my garage !!

 

It's because the rod now needs to be ever so slightly longer again, just adjust it.

 

That picture was with extra part fitted this is now

 

Looks like you're changing the orientation of the shift linkage between those last two photos. Maybe that's got something to do with it? Are those hm shift sensors both push and pull and do you have to change them over in the settings?

 

Don't know and how do you change them over

 

In the top photo your shift linkage is running above the gear spindle. In the bottom photo the linkage is running below the spindle. This will change it from standard to race pattern. Maybe this is messing around with your quickshifter.