Separate names with a comma.
hello everyone, 2014 was a right off for me, job promotion, new house, study and exams etc.
House almost sorted so back on the blade for 2015....
Welcome in mate...........................Repsols, the fastest colour too ;)
Clutch dependant I'll make one for McD's at 0900.
Spoke to Jkaye this morning.
These are top gloves, the new ones are even better and it is true, buy a size bigger than usual!
Martin, I will be there tomorrow!
Jase, PM sent !
I did mate, had a quick look around.
Fez, Im not here next week but would be good to catch up sometime. Plenty of members old and new in the...
Loads of Blades in Squires tonight, the place was heaving.
Too many to mention!
Hello mate, lost a couple of these and need to replace them.
Part # is PFKL1012718 I need a couple but will take 5 or 6 to have some spares....
No worries mate. Couldn't remember if it was a 750 or a 9, the lad I knew was called Jase, and was with a girl called Tina.
Mine's a Berik one piece and to be honest I bought it cos it fits and feels supportive. Number one thing for me was fit!
Iv'e had it 4 years now...
Different people read the same sentence in different ways, I always try to think how I would read something that I had posted and see how it came...
Hur fuc*ing rah !
Most sensible of ideas there Martin..!
P.S. twas very nice to meet you at last years Bike Show!
Hows the knee holding up?
Welcome in Drew, keep it shiny side up !
Nah then matey, welcome to the site. Did you used to have a ZX9 too?
Got the Blade back after having the clutch mc repaired.
Now fully functional again woop woop !
"I hope this helmet's got a good Sharpy rating " cos this is gonna smart a bit!
Welcome in mate, will defo see you at squires! Are we starting to get a "northern monkeys" section :D
Fluid res mate, gonna try letting the bike warm up, could be air in the system or possible slave cylinder, that's what I'm being told from my...
Got up to take bike for mot and no pressure at clutch lever!
No fluid leaking anywhere and tbh that's about as far as my mechanical knowledge...