Separate names with a comma.
Ok I'll have a look. Do you know what the readings should be?
If I remove the pc3 it starts first time every time
Hello, I have a 2006 RR6, And I had the intake flapper done so it stays open but I have put a power commander 3 on the bike takes about 5...
For some reason I got into a really bad habit of using alot more than I should. Cause prior to this it was fine
I thought it was the pads so I bought disc and pads . Might just give them a good clean up and see what happens. And send the discs and pads back
When using it
Hello I have a blade rr6 and I have noticed at low speeds my rear brake makes a fog horn sound. Any ideas what may be the problem Thanks Tony
I'm was use to a RRT compartment which you could fit your week's shopping in there. I'm wanting to properly fasten it in but I can't because of...
Hello, I'm thinking of getting a USB/CHARGER /volt meter for my RR6 2006. I'm Just wondering if anyone has installed one before and where have...
I have found out that I have a little movement in the fork tubes not the head stock
When I was push/pulling on the bottom of the forks it did look like it was the fork tubes that were moving, but going away for a week so when I...
Sorry forgot to say it a rr6 2006.
Hello I'm after a bit of help. I thought I would check the front end of the bike and I noticed I had abitplay when pulling /pushing the bottom of...
Does anyone recommend NSK Bearings? Or. EEC Thanks Tony
OK no problem thanks for your help mate
I did but it wouldn't fit inside the hub so had to use the old bearing
Ok, I'll knock them out if I can move the spacer. If I grind the inner race of the old bearing so it's not as wide. Or ill try and find...
Yeah that's exactly what I have done as the socket I used to tap the new bearing in wouldn't go inside the hub so I used the old bearing.
Do you think it would be ok to put back together with the bearings being tight up to the tube?