Separate names with a comma.
I got Venhill steel braided lines from AS3 Performance, as they were a very good price. Quality-wise I would say they are top notch - very nice...
Pads installed, along with brand new stainless steel bleed nipples. [ATTACH] [ATTACH] [ATTACH] Caliper spacers fitted. From the factory, they...
Next - front brakes. Remember the fully stripped down front calipers? [ATTACH] Turned out, the pistons were previously removed using pliers...
OK folks, time for an update. Radiator in place, finally all hoses connected and filled with coolant. Do you notice anything strange about the...
PM
Thanks mate. I did have a bit of a stumble with the fuel pump not priming. That is until I realized I need to bypass the bank angle sensor as...
https://streamable.com/olij4 A little preview :D:D:D Started right up and runs great. Disregard a some buzzing noises picked up by the phone mic....
I am using the stock clip-ons, but still the bulky controls and cables are not needed.
Chain in place. [ATTACH] [ATTACH] I tried blocking the rear wheel from turning with a wood strut, in order to remove the front sprocket. Don't...
This is how the bike sits as of now. Should be ready soon enough. [ATTACH]
There are 2 vacuum / air inlets that need to be plugged. First is the airbox inlet for the PAIR system on top of the valve cover. Since I have...
Finally I decided I will not have the left clip-on headlight controls installed. Too bulky and thick cabling for something that I will not use at...
Anyways, back to the bike. Mid pipe and slip-on mocked up in place. [ATTACH] [ATTACH] Rear wheel installed. [ATTACH] [ATTACH] Lambda sensor...
Let me tell you about my experience with the original forks. As you probably remember, they have been revalved by K-Tech, so its safe to say I was...
Check this out for pin sizing: http://www.motorcyclegear.com/info_pages/application_chart_dmp_head_lift_stand_pins.html You may have to request...
It was an inexpensive eBay one, cost around 60 quid when I bought it a few years ago. I THINK it is this one, at least looks identical:...
On a general note, you guys have probably noticed I am now bolting on parts which are not perfectly cleaned, painted etc. I put a lot of effort...
[ATTACH] [ATTACH] [ATTACH] Headers installed. As I said not too polished, but may end up taking them off and trying the bleach treatment....
Thanks Nigel. This is how I got the wheels, I haven't painted them myself, I just cleaned them thoroughly. TBH I am not a huge fan of sprayed on...
Wheels prepped - new tires, seals cleaned and greased, rotors in place, sprocket carrier cleaned and installed. [ATTACH] [ATTACH] [ATTACH]...
