Separate names with a comma.
More parts ready to be installed. [ATTACH] The Leo Vince slip-on is in pretty decent shape aside from the crappy peeling spray paint on it. I...
New tires ready to be fitted and also the oxygen sensor - stripped off the old burned insulation and wrapped in some heat resistant tape....
Just a guess, but I don't think they are specific to cylinder number. Most likely the upper and lower are different though.
Hmm, I've seen the Harpic videos... never occurred to me to try any other bleach product. May give it a go, thanks for the advice.
Exhaust bracket cleaned, polished and new stainless bolt to replace the old rusty one. [ATTACH] [ATTACH] [ATTACH] Rear sprocket carrier and...
With the coolant hoses installed, its time to sort out the headers before mounting the radiator. [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]...
Coolant hoses installed. It took some trial and error and lots of staring into the manual routing diagrams, but finally everything in place...
Rizoma engine case slider installed. Kickstand bracket installed - I will not be putting the kickstand on, but still need the bracket to mount the...
The dent was pushed out a little bit with a wood rod though the fuel pump opening and a hammer. Couldn't do a very good job, as the internal vent...
You may have noticed the fuel tank laying on the ground in the back on some of the older photos. It was really dirty, a bit scratched and had some...
Thanks, it does indeed. Funny thing is, take a look at the footpeg on my old 900 blade in the back. Both are ground at an angle like that and its...
And finally rearsets and rear brake mounted on the bike. Not sure on the footpeg position yet, this will be adjusted once I take it to the track...
[ATTACH] [ATTACH] Clutch perch bits cleaned and assembled. [ATTACH] [ATTACH] Rear brake caliper, support bracket and master - cleaned and...
Rearsets disassembled and thoroughly cleaned. [ATTACH] [ATTACH] [ATTACH] [ATTACH] Put back together [ATTACH] [ATTACH] These are no brand...
Test fitting the airbox and routing the harness around the fuel/vacuum lines. Bottom row injectors, servo, TPS connected. Upper portion of the...
The mallet is my negotiation tool :D Convincing stuff to fit when it doesn't want to. In this case the throttle bodies into the rubber intake boots.
Not much to describe here - throttle body and cables installed. [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] One slight concern is at what...
Neutral sensor connected and tapped into the harness. [ATTACH] [ATTACH] [ATTACH]
I mentioned several times that the second wiring loom I got was off a 2015 model (even though it was sold as a 2008, the part numbers and the...
Thanks, it is coming together nicely :) Sorry for the poor quality, but I did take the clip through the messenger app to send to a friend....
