Separate names with a comma.
Yes I use Gilles they are very good, easy to adjust on the bike to get the height you want
Brembo M4 Monoblocs are great, make sure they are the real versions so 34mm Pistons all round, SP versions got a cut down with 2 32mm pistons and...
2012. Fans not needed.
I will take it if it's for the exhaust servo.
But only by the skin of your teeth..... but well done.
Also bear in mind this setting reacts to a chain tightness that is spot on, when it was a bit slack it missed like a sod, so again dependant on...
[ATTACH] This is what I use, I have Gilles VCR rear sets so perhaps this is slightly different to the standard foot peg set up
No they are Koyo and expensive. I did hit a rather large pothole and this probably broke the bearing and seal.
[ATTACH] Mine after about 10,000 miles
The Ohlins rose joints are easy to replace, they do wear with age given there is no seals in them, I replace mine every 8 thousand miles, cost...
Adjust it while the engine is hot, slowly turn the screw until slight resistance is felt, this is the plastic runner touching the cam chain, run...
I got fed up using the Honda parts,after 2 failures I now use a the ape version, adjusted it once only, have not touched it in 7000 miles
anything considered, don't have to be in perfect condition as long as they work.
Head bearings, I had the same issue. Cured by fitting a taper head bearing.
Yes a good idea to start again from scratch just in case Sent from my iPhone using Tapatalk
What engine oil are you using and what grade? Ie- 10/40w
Have you checked the sensitivity with your hand?
Crikey that's a naff picture but you can see where I have positioned mine.
[ATTACH] Mine is attached here, where is yours? Sent from my iPhone using Tapatalk
Yes I tried shorter times but it made the shift far too agressive and not pleasant
