Separate names with a comma.
Cam cover gaskets are pretty reliable only seen one split when owner tampered with it during a rebuild. Look at the breather pipe from cover to...
Get a replacement Guy, don't mess around with a repair job it would still have the weak spot.
Since you have already lifted the tank then its a strong possiblity one of the hoses on the 5 way adaptor has come off. Buying used PC or alarms...
The 2004-5 blades do not have an o2 sensor
If you have lifted the tank recently you might have pulled off a vacuum hose that would cause those problems. Its easily done due to the tight...
Sad news mate. Did'nt the dealer advise you about the silicone on new tyres???
Twas a chappti roll unbeknown to my feathered friend it was 100% mutton not beef. lol
A Brahmin kite is regarded by Hindus as being sacred, dont know why when one dived onto my lunch.
Have known the CCT spring to collapse causing an extreme racket from the cam chain. This unit can be removed to be checked before you fear the worst.
When you swapped engines the camshaft sensor on RR7 has a different adaptor to the RR4 loom, I had to remove the exhaust sensor of the RR4 and fit...
I have a RR4 and have fitted a RR7 motor with no problems, however if its been wired up incorrectly the ECU would go into safe mode meaning it...
Looks like the tilt switch in the cockpit is the culprit. Re set igntion all should be well hopefully!!
Recently used brake cleaner and set the kitchen alight, this stuff is bloody inflammable and took the little hair I had. Thought in forestry it...
Datatool have a poor reputation sometimes unfairly as I've fitted many,many units and when they pack up you wont get the bike started at all until...
One peice leathers in HRC colours for a mere £50, could'nt afford the price of the more established make at £1400
Hydraulic fluids discolour due mainly to constant use moisture plays a smaller part in that. Checked the clutch reservoir the fluid was like...
Hi and welcome blade lover. The hydraulic clutch is a right beggar to bleed to get maximum pressure at the lever. Have found the conventional way...
The easiest way to get the bolt off was to use an impact wrench the small 12volt job coming off your battery. Needs to be in gear first when...
Yes Steve Buckley it is me again. When forums started to take off there was a lot of non-sensical squabbling whereby I became the target for many...
1992-93 were the same generation the only difference I can recall was colour change and graphics like a purple passenger seat cover. There was no...
