Separate names with a comma.
First bike a CZ125, then a CX500. Then a break of 32years and bought an RR7, and managed to survive!
Yes, and the pins will not budge on the female part, the one on the left in the photo.I cannot figure out what's holding it. Do you know what they...
Yes that's them, great, where you get that pic? I was trying as you say but couldn't figure out where the releasing bit was.
I've had a wonky rear indicator for a while and decided to open the loom connectors and clean up the contacts properly. I mean the oblong coloured...
I bought both my compressors from Aldi, a 25lt and a 50lt, they're great for the money. I blow my tyres up with stirrup pump again from Aldi,...
Thanks for the advice/tips.
Touch wood, I've never needed a rescue but used to carry the number of a man with a van kitted out to move bikes. He seems to not do that anymore...
Hi, what do you use for the inevitable?
R5s, I remember first wet white line I touched it just rode up, no slip.
it's less than 0.5deg out but still I'm surprised. To fabricate those pieces is clever stuff, welding order etc. so it comes out straight.
I found dowels that were a good fit in either side of the swingarm pivot bolt and the rear axle. Each end is a different size. Then used a 600mm...
Checked my 07s, spot on
Wow, I'd have lost that bet. How did you measure to the swingarm? I've got a couple of long verniers.
This is may not apply to other years but the 04-07 swingarm bolt's hexagonal, on the off side, is a bastard size. To torque the lock ring on the...
out of curiosity, how good were the swingarm graduations compared to the alignment tool you made?
I've mentioned this elsewhere, but I've just fitted a 19mm Nissin master to my RR7. It's basically the bigger brother to the 17.5mm OEM. I had to...
The way I do it; split the caliper, put each half in a plastic bag, and with my thumb holding the smaller piston (lower one) in place, put my air...
usually one will fly out first? then what?
Funnily my experience is only RR7 too but I know how to do it. The Honda manual says remove the throttle bodies and lift it off but it can go...
19mm master fitted and the lever is harder but the travel is still too much. Did the same test to find where the piston crossed the fill port and...
