Separate names with a comma.
Welcome mate. Visited northern Oregon in 1992. Beautiful state. Drove along the south side of the Columbia river and viewed all the dams and...
They are spacers to stop you crushing the o or x rings. Remove them after fitting link.
£30 plus postage mate. Brand new , never fitted.:D
I got these brackets. Dunno what make they are? [IMG]
So you are revving the tits out of it in the lower gears and spending very little time at low revs in higher gears? Nuff said;)
Hump,are you getting the bike into the higher gears? If you are , then you have a problem!!!
I buy A4 stainless Allen bolts from a local supplier. Around 50p each . Not over £4 each plus postage. Pro Bolt are thieves.
Oh yes mate. Just a bit of surface rust, but higher lift cams than the ET ones and I can dial in lots of overlap for more top end. Don't need...
No mate. The prescence of elongated slots in the cam wheels indicates that these camshafts have already been used in a race engine!!! Elongating...
Well Ken, the position of the cam sprockets in relation to the cams is critical. Normally held in position with a fitted bolt!!!
Charge it overnight, check battery voltage just before you ride it. Ride to stealers and then check voltage again?
It could just be bad battery connections, but it needs checking under warranty.
The Optimate is charging , but when you ride the bike, the battery is not being re-charged!!! Problem with battery, reg/rec, alternator or wiring.
Nope! Not enough volts in battery. Fully charged should be 13.5 to 13.8 volts. Check voltage at battery terminals with engine running and charging...
Not had much time in the garage recently , but I managed an hour today. I was given 4 camshafts to clean up and use. They looked like this; [IMG]...
Get the bike shop to do it and then you will know for certain that the book has been stamped properly!;)
Did a 24,000 mile service on a mate's FZ1. Not finished yet, waiting for new shims for exhaust valves.
I'm a snob and I'm ignoring you peasants.
It,s only one tooth mate. OK as long as the spindle isn,t right at the front of the swingarm slots. Why 520 chain and sprox? Saving weight?
Agree with you there sinewave. Where do these stories come from???
