Separate names with a comma.
Like a noob I didn't allow enough scrub time for my new PR4. Done about 150miles on em which is usually enough for me but they gave way and the...
what map is that, I'm using M16-002-501.pvm 2009 Honda CBR1000RR European model Stock exhaust Stock or aftermarket air filter Dynojet o2...
The PCV map doesn't really do much in that area see generic map for a standard blade [ATTACH] Most of the benefit may come just from the...
After 20K+ my Tsubaki Sigma chain is proper fecked. 15mm between the slackest and tightest spots. on inspection there was some serious play...
Maybe you have an air leak in your exhaust?
https://www.youtube.com/watch?v=r_5Lx-0KWqM this demostrates it nicely. To remove seat you need to pull off the plastic covers under each side...
Disconnect battery Reconnect after at least 10min Start up without touching the throttle Let to run until the fan kicks in turns off again...
Try the free stuff first, adjust the throttle free play and chain slack makes a lot of difference if then are not adjusted properly. Maybe even...
I have an OEM with a PCV. Runs very nice! Smooth throttle response and better economy to boot. More to be gained if you did have an extra market...
Is this HGB? I normally get them to fit loose not sure if they have the policy of fitting on bike only if bought from them
Some say you should only use Silicate free Antifreeze on Hondas, apparently the water pump doesn't like it. There lots on the net about it - TBH I...
The ABS cover is easy, the sprocket cover can be a PITA to remove and refit. First time it’s fiddly and messy. The sprocket cover has sensors...
^^^ best done with a PCV or similar. I ran my last CB1000r with a Leo and decat alone and it run OK, good at WOT but at small throttle openings...
if 2008+ under the tank left hand side
Cant answer your question but easier just to block it, takes the hassle out if you wish to return it back to standard when selling.
I've been looking to do the same for while now. Nearly purchased the Nitron off Daz but from all accounts from Nitron themselves it doesn't fit my...
I checked with one of the tech guys a Nitron. I did mention that the Ohlins equivalent is the same for both the non and ABS models but apparently...
Dang just checked with Nitron for fitment to an ABS and the computer said nooooo.. Otherwise would be all over this!! Am sure this will be taken...
Honda CBR1000RR 8-D (530 OE) 08-13 Ognibene 16T Silent Front Sprocket (STD Size) | eBay [ATTACH] like the fact that it has the rubber damper...
Hi Andy, It's that time again to change the C&Ss on the CBR1000RR 09. Please can you give me a price for : Renthal front and hard anodised rear...
