Separate names with a comma.
What size front tyre profile are you running tyke?
Also meant to be a 1-3 ratio so a 2mm shim would raise the rear by 6mm!
Just had a quick google m16 (reactive suspension say m14 for r1/r6) washers is meant to correct size, as far as c shaped washers what's wrong with...
Is the r6 rear shock not a similar setup for shimming the rear shock as the gsxr's ie just head down to b&q and pick up some big washers n put em...
I wouldn't say Suzuki have any better luck with there OEM regs they recalled a series of bikes as they regs were catching fire burning the bikes!...
Wedge I hope your not insinuating jase's race will be over within 5 mins? Jase, just mind and keep it rubber side down on the black stuff, stay...
leave the bike with whats in till next service it will be fine, Honda only recently changed there mind about what oil the blade should be running...
Pretty sure the Tps sensor plug and the Map sensor plugs are what a lot of people get the wrong way round when fitting the likes of the Power...
Do you need to charge the lid up before heading out anywhere? ;) Its got an iphone charge cable going somewhere! :D AGV lids n ma heed just dont...
silicone might not stick too well to the smooth plastic finish on the bikes panels, also it may peel during first wash as the mitt wipes over the...
Not sure what off the shelf glue would allow same removal at a later date n not cause any damage. but you could use a little strip of venture...
Hmmmm...Not sure I agree with what you have been told by the dealers there mate, Both have the same cold operating temprature range thats the 10w...
Not sure if I have over complicated the whole process by trying to go through everything in as much detail as possible because tbh its not really...
Your shipping costs would be pretty high............. :) Cheers, It took ages to actually write up in a manner that I think folks can follow....
Ok Folks, Think I have most of the guide kinda laid out in a more readable way. :) Any thoughts on any changes or ways to make it better or...
Step 38. Once fork has been bled it is time to set the fork oil level which will be attainable from the service manual for the bike. While...
Step 27. The forks should now be thoroughly cleaned to get rid of any old oil, muck and gunk before starting the rebuild process. Step 28....
Step 18. Next turn the fork upside down and drain all the fluid out Just note the cartridge rod will probably make an appearance at this point...
Step 13. Now put the fork compressor of choice into the holes that are pre drilled into the plastic spacer. The spacer has to be pushed down in...
Step 9. Slacken the two Allen bolts on the bottom yoke and slowly drop one of the forks down and out of the bike. Use one hand to stop the fork...
