about to fit an gpr end can, any adviced on the cable connected to the flap on the existing can? do i have to strip it right out, what are the problems ect, not much of a spannerhead i,m afraid.
Just disconnect it from the servo mtor under the seat but make sure you wind it back to original position, then just pull it through still attached to original can
if i,d looked earlier i would,ve seen the link to the you tube footage on removing the exhaust. doh! not the best at reading instructions, just charge on! all done now though, looking and sounding very nice!
Was just about to post photo after lots of grief with photbucket when my laptop crashed. Lucky i kept a cool head and didnt launch it at a wall. No a good day as i,m about to post elsewhere.
